Clinton-electronics CE-T909 Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Kamery Clinton-electronics CE-T909. Clinton Electronics CE-T909 User Manual Instrukcja obsługi

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 2
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 0
Included Items:
• Camera x 1
• Allen Wrench x 2
• Instructions x 1
• Phillips Head Screws x 3
Required Items:
• Phillips Head Screwdriver
Optional Items:
• CE-REMOTE
• Drill w/ Phillips Head Bit
To ensure quality operation, verify proper BNC and power termination; along with proper
voltage at camera.
TO DVR/MONITORTO CAMERA
BNC CONNECTION
POWER CONNECTION
T909
1. DISASSEMBLE
2. CAMERA MOUNTING
4. REASSEMBLE
INSTALLATION GUIDEINSTALLATION GUIDE
3. ATTACH CABLES
a.
Place the camera body into the socket of the mounting plate. Then place the outer
plate over the camera body and mounting plate. Loosely tighten the set screws to hold
the camera together.
SET SCREW
MOUNTING PLATE CAMERA BODY OUTER PLATE
Ax the mounting bracket to the surface with the 3 supplied Phillips head screws. Feed the cable from the camera through the center of the mounting plate. Make connec-
tions to the BNC cable and the power connection. Feed any cable slack into the
mounting surface.
a.
With the supplied Allen wrench, loosen the 2 set screws located on the outer plate.
b.
Carefully seperate the mounting plate from the outer plate and camera body.
b.
Remove the protective film over the lens.
v.05.29.13
The set screws will be tightened after camera adjustments are made.
*Information in this document is subject to change
Clinton Electronics
Przeglądanie stron 0
1 2

Podsumowanie treści

Strona 1 - Clinton Electronics

Included Items:• Camera x 1• Allen Wrench x 2• Instructions x 1• Phillips Head Screws x 3Required Items:• Phillips Head ScrewdriverOptional Items:• CE

Strona 2

OSD CONNECTIONZOOM5. CAMERA ADJUSTMENTa. Camera plate rotation can be adjusted by turning the camera to the desired location.SET SCREW360°180°c. Barre

Komentarze do niniejszej Instrukcji

Brak uwag